Jump to content

DIY Mini Meet in Austin


swt61

Recommended Posts

  • Replies 134
  • Created
  • Last Reply

Top Posters In This Topic

don't even go down that rabbit hole of fail, trust me :) just under bias the thing.

Sounds like a plan. So if I want to build another one, would I need two of the huge DIYAudio group buy sinks per side?

For the "bad" channel, what is the drop across R3 and R4 (2.2K)?

I'll measure it tomorrow and get back to you. :)

Link to comment
Share on other sites

Continuing on my own personal trail of fail, the BH comes up today way out whack from yesterday, but I can get both +- to 1v, and the delta to ground to about 3v on each side, but...

Yesterday we set bias at 560v... today it won't go above 527v... what the fucking fuck?

DIY was invented to try (wo)men's souls... and a walk through my DIY soul / sole would scarcely get one's feet wet.

Thinking of some shallow, meaningless hobby - and no doubt there will be suggestions.

Link to comment
Share on other sites

I didn't set it, did you?

I'm mixing that with Vulcan... BTW, great job on the Vulcan bias, Naaman.

Fork. N/m... but, still begs the question what is the bias issue - rails are good at 373v at the boards, and the 30v is right on 30v at the psu. LEDs are all on.

Like giving a monkey (not THE MONKEY) the controls to an F-16 in mid-flight.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.