The ultimate DIY? A Stax SRM-T2!
I bet everybody knew this was coming but we've been moving fast and the board is taking shape.
If it's not clear from the photo then this is a massive slab, 16" x 12", so quite a bit bigger then the production version. It will be built like the BHSE with the board mounted to the top of the chassis, with the tubes sticking out of the top and the components on the bottom. Massive heatsinks are needed to keep this beast cool and a single angle bracket is used on each side of the board to
I organized a DIY T2 chassis group buy a couple years ago, and I've had a couple people inquiring as to whether I could do another. So putting this out there to see whether there is sufficient interest in doing it again. I would need at least 5-6 participants for it to be viable. Last time the cost of the chassis was $1500 ish, with anodizing, holes tapped, brackets are laser etched faceplates. Before I place any order, in the event there are enough participants, I would need a $200 up front com
