mattmatt

I'm not planning to use any other boards other than the ones I have currently so i'll be using the +/-15V on board. Stupid question. What's the reason to use dual secondary winding vs single winding and just splitting wires into 2?

Oh, you're right! I've been trying to download everything by clicking only. never thought of right click and save as. My stupid ass's mistake. Just wondering, I'm no expert with transformers and all, what does this mean? For a 400V PSU: 2× 335VAC @200mA 16-0-16VCT (anywhere from 15-0-15VCT to 18-0-18VCT should work fine) @500-700mA (the higher amperage is way overkill) Do I need 2 secondary windings for the 335VAC and 16VAC or 2 split leads will do?

Hi Pars, Thank you for your reply. I appreciate it. I was kinda worried that the thread is old and no one checks on it. Here are the photos of the PSU boards. Just want to ask for verification, the goldenreferencehvsic is the whole schematic for the 2 boards? Doesn't seem complete to me. Do we also have an existing BOM right now? Every link that I try to open are dead as of now sadly. I'm kind of embarrassed to ask here coz I may sound like an idiot. I've read the forum quite a lot repeatedly but still seems loss at some points.

Hi guys, I've had these boards for a few years now and want to build them now, I have a full folder of the golden reference and kgsshv carbon schematics and pcb layout prints. There are a lot and confuses me. Below are the boards that I have. I hope some can point me to the right file for the PSUs and amp section. Can someone verify if this is the proper schematic for the amp?