May 5, 201016 yr comment_350453 I have some of these Chinese "CMC" type RCA Jacks. They have a knurled ring that has indents for some type of PIN wrench. What do you guys have for these to keep them from getting scratched up via pliers? PIC Report
May 5, 201016 yr comment_350463 I just finger tighten them, or use needlenose pliers in the notches. Or put a rag around the knurl and use channel-locks. I believe they do make a wrench for them though. Report
May 5, 201016 yr Author comment_350484 I tried that a little on a set that was installed on my DAC, and they were put on pretty tight, so they must have used some pin spanner or something on them. Not a single mark that I can see? Report
May 5, 201016 yr comment_350557 RCA-805-Tool Audio Catalog only $28 (plus shipping from SE Asia)... Report
May 5, 201016 yr Author comment_350567 RCA Socket! Go figure! Thanx, that vendor always has interesting stuff. Report
May 5, 201016 yr Author comment_350574 Gets a little more expensive if you brand it a little apparently... WBT 0299 (ea.) RCA Socket Wrench Check this out for added fun! Look over the individual PIX http://www.worthpoint.com/worthopedia/vintage-rca-fingertip-wrenches Report
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.