Jump to content

jose

Returning Member
  • Posts

    1,817
  • Joined

  • Last visited

  • Days Won

    6

Posts posted by jose

  1. For me it is difficult to distinguish anything.

    Resistors look like Vishay RN60. I don´t think they deserve to be changed unless some are burned.

    Wires, I don´t use anything specific, just a cable with an adequate thickness and a good dielectric. For the audio signal I sometimes use shielded wire (for microphones or music instruments) sometimes I use Mogami, Canare or just the one available in the electronics/music instruments store of my city…. nothing esoteric.

     

    Edit: This is my opinion. Obviously you can use the material you think is appropriate.

  2. Updates: 

    . With the E80CC has more gain. I think it is an improvement over the 6189. I like it much more with the E80CC.

    . JJ octett EL34 matched, off set is around 1~2volt. Balance 1~2volt too. It really deserves to invest in a completely matched octet (It's expensive but it makes up)

    rGhkwAt.jpg

     

    AtXtb73.jpg

     

    Did I say that it runs very hot? 

     

    • Like 2
  3. I´m using the same kind of socket (but I prefer bakelite). So far I have not had problems.

    You can solder them to the Pcb without problem (always when you have a powerful soldering iron, about 25 / 30W).

    I recommend that when you solder them to the plate, you have a valve inserted. This will keep everything aligned. 

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.