naamanf

Table put together. This thing is yuge!

I’m guessing I must have missed someone asking about them. I will probably make nicer looked hangers down the line but these were quick and easy.

Finished running 6” vacuum line and setup automatic blast gate for the CNC. Time to start putting together my erector set.

I played for 5 minutes. BORING.

Yes, table saw. It was early. It looks easy to make on a table saw, but the dimensions didn’t look correct when I imported to Fusion.

Do you have the Fusion file so I can see the dimensions? That looks like it would be easy to make on a table table actually.

I would finish with Wilsonart or if you really want to paint something on, Duratex or ExoHyde. This is a Duratex I did on my theater speakers. Incredibly easy to roll on in one or two coats.

Using good finishes helps, but finishing is my least favorite part as well.

Rip chuck. His son was in my R/C club growing up in Oregon. Guess they didn't get along so well. Something about a big ego.

I contacted them and they said they have a 5 year warranty and they will replace them. Little worried with that high of a failure rate, even if they do replace them. Lifetime warranty on all the track, which I think is pretty failure proof.

Those look pretty solid, I’ll have to check them out.

How are those Armour clamps holding up, Marc? I’m going to use a lot of their T track for the CNC hold down and like the clamps but I bought one from Amazon and it came DOA.

Aligned up my fence. Close enough for me. Put together a cross cut sled. Square to .00022 per inch.

I see one of those in my future. Built in dust collection? Take my money!

Looks great!

Is that purple stuff rough cut? Very Flat?

Rammstein meets Trans Siberian/Mannheim Steamroller

Baltic birch would be your best bet.

You should see the gimp suit.

Installed a pair of procedure lights.

I think I might need to modify the table saw. Incra fence. Pfffttt.

Put up a dust collector. Still waiting for the filters to show up. Time to run 6” duct lines everywhere.

It was the winner.

Workout space started. Need to get my soldering arm back in shape.