pcb mounted sockets

[crappyjones123]

I had a problem with the last amp i built with pcb mounted sockets where the tubes werent straight (probably because the sockets werent parallel to the board. anyone have any tips on how i can get the sockets all mounted level so the tubes can stick out straight?

[MASantos]

you could make a 90

[digger945]

Put a tube in the socket, then use chipquik.

[Pars]

I usually use strips of masking tape to hold stuff on the board while I solder.

[n_maher]

I usually just solder the sockets from the top, one leg first and then another on the opposite side so I can adjust if required.

[holland]

I do the same. It also helps to push it down, hard so it sits closer to the board. Solder from the top, and then adjust.