DouglasQuaid

YES! Let's have a costs vs prices on consumer electronics discussion for the 9004th time.

This song is just six words long. This song is just six words long. This song is just six words long. This song is just six words long. I mean it only as a sign of respect. Anytime someone mentions George Harrison, I get that melody stuck in my head for hours. Whistling it now as I type.

Since most all of my listening is done through usb, I'm tempted to pick up this board for the improved USB connection. Then again, spending another $800 takes the PWD a bit past the pricepoint I was originally wanting to pay for a DAC.

I was aiming for 20, but exceeded expectations by 25%.

I wrote one. http://www.head-fi.org/t/577060/irvine-orange-county-meet-impressions#post_7843639

Is it too late to throw myself into the mix for 4 pro-bias jacks?

When I built my reg. kgss, I set the input fets close to each other, but didn't bother gluing them. The dc offset never got too out of hand. It did move a bit more than I liked during warm-up, but it was still well within safe limits.

I only posted that to give you an idea of how blatantly they hammer people for repairs.

I'd like to think whoever made that pic was tripping balls while watching HeMan and drinking eggnog.

I've pulled my sr007 apart. If i'm on the same page with you here, you'll have to disassemble your driver housing to get inside the piece you're looking at. Not a very minor job. Yamas wanted $1800 for driver replacement (replaced with mk2)... more expensive than just getting another sr007 mk1. They're awful and should be bypassed whenever possible.

Got mine a while back. Thanks Kerry. Now to figure out what project to put them in.

I might know a guy in the area with a kgss... just sayin'.

ED? I hear that's treatable nowadays.

From yamas: "There is only 1 driver for both MK1 and MK2 and cost is approx. $1800." Anyone have some lube? Apparently replacing the drivers on my mk1 to make it an ugly mk2 will cost more than buying another mk1.

Is there any way to source these? I believe my squealing SR007 need new drivers and I'm too afraid to send the pair to yamas. I fear they'll just put on mk2 drivers, charge me a whole bunch of money, and you'll all have to witness a grown man crying.

Can you mark me down for one more kgsshv psu board? Thanks. Will send payment upon response.

Guess it's time to start that DIY Time Dilator thread you've been dreaming about. Libya's in shambles... probably wouldn't be too hard to get some plutonium now.

Updated spreadsheet for my requested items. Looking to get 3 KGSSHV sets. One with on-board sinks, two with off-board sinks. Also looking for one dynahi and one dynafet boardset, each with 2 psus.

I should petition for the MOT: Suck Suck Suck title.

I'll get the payment for you soon. My paypal account is freaking out.

My favorite part about solid state. When you blow your load, you just have to make sure to avoid the cable.

I play the occasional game and watch tv shows on my PC, so this is quite a dealbreaker for me.

I assume it's still perfectly capable of mounting to an angle bracket for those of us without industrial grade mills.

Only terrorists and pedophiles put the volume knob on the left. CT = Center-tap.

I would rather rig up a set of switches to look like Hello Kitty.