Looser101

Our first snow this morning. Took awhile to get in to work. 4WD FTW.

Happy Birthday!

Happy Birthday!

Happy Birthday!

Happy Birthday!

Happy Birthday!

It's always fun the first time...

If you have another set of output tubes change them out.

I checked your work against the manual and I don't see anything obvious. Solder joints may be a problem as some still look iffy and I can't see jumper J2.

There should be two "D" voltage measurements, one for each side of the tube, but I doubt that is the source of the problem.

Caps look oriented correctly. Resistors, from the colors I can read, also look correct.

Is that Red/Yellow wire soldered? Left side from power transformer.

I see some potentially bad solder joints: Pic 2 right below the left tube socket. Pic 2 to the left of the right tube socket. Some of the other pics are too blurry to be able to see much. Some additional heat or on time might help flow some of those joints better.

Unacceptable! Where is that Guzzyguy, guinea pig. Surely he doesn't need one, but he should take one for the team, this time round.

Bought one too 'cause I like to blow shit up. Better "it" than my Fluke.

Philodox (don't call me Phil - Jay), Pixel Pusher (Kev), me, Hywire (Mark), Aerius (Eaphan).

If you are ordering poutine in Ontario then you are probably from Quebec. Real men order chili fries.

Only in French Canada. We "normal" Canadians don't have that issue.

Thanks for the impressions.

Close enough.

Pffft.

It was too wide to fit in the cabinet, with the feet on. Just look at my Avatar.

Happy Birthday!

Myself, Philodox, Hywire, Pixel Pusher, Aerius. Sorry, my rig was not in attendance. Only my headphones. I brought Pixel Pusher (Kev) and his rig. Between his Esoteric and his McAlister, I think I have a hernia. No desert, but key lime pie girl can sing.

Shunt Pot Volume Control - World-Designs-Forum No idea on the pot.