DigiPete

Ok, I see a jumper hole near C15. I guess I didn't read the big print right there Do you think that is likely my issue?

The second board is assembled, but I did not put in the transistors you sent, until I debug this board

huh ? Where is this on the board. Could this be the cause of my bad readings?

So is the voltage at the transistor quad and output cap... The resistors are all correct, and I ohmed them out before install. After building an M

My experience is that most of the LPs I get from the used record store, (and I look to make sure they are in good shape to begin with, outwardly) clean up very well, to the point were I don't mind playing them. There will still be minor clicks (can never get rid of those) but usually no loud pops after I'm done cleaning with the VPI 16.5

Q3 30.6v, 26.68v, 30.3v the Q4 and Q4 base voltages are near 29v

input voltage from big cap 46.8 volts (don't know if too high an input voltage can screw the circuit) across R2 .08v at regulator input 46.7v at output 30.7v at zener 9.45v R27 47k is in voltages at Q3, Q4 and Q5 are where it really gets fucked up.... stand by

Well, I soldered in the final transistors from Marc today, and..... the circuit not measuring right, no workie.... I will need trouble shooting assistance:mikey2:

The AMR certainly is a very nice looking unit.

Anywhere between San Diego and Sacramento...

Having had a vinyl rig growing up, some clicks were always part of the "normal" experience... So getting back into it now, it has been less distracting then I thought it would be, but I could see how a CD baby might have a harder time adjusting. All that said, a good stylus (micro-line or micro-ridge or the like) gives you a quieter ride, and the cleaning machine helps tremendously.

I'll be sad the day I run out :'(

Broiled Alaskan Halibut with some veggies

Any luck finishing those transistors

My Denon DL160 came with an extra weight (plate) that you could mount between the headshell and cartridge. I think you can buy those as well. Just make sure you get truly non-magnetic ones.

Toshiba...

Wrong part number

:prettyprincess:

I want my Pearl Phono trannies

correction: non-prescribed/illegal drugs....

I would advise to stop, or, not start drugs.... ever.

Just got done doing a Baerwald alignment on my turntable cartridge. Wow, the Technics cart positioning guidleline is 3mm off compared to Baerwald.

Yeah I saw that ... Intriguing!

Any opinions on the Zyx bloom (.48mv) cart? Seems to have some very glowing reviews.

Thanks cetoole.