naamanf

Obviously.

I’m pretty sure Bob was canonized as the Saint of Woodworkers.

Yolo.

Secret Santa gift for a whiskey group.

That’s awesome, Nate! What drag bit did you use, been so differing picking one up instead of outsourcing to a trophy shop.

Business side of the cutting board. Figure it will have a long life serving charcuterie to Marin’s finest.

Well darn. I’ll leave it as is for the official christening.

I also made a cutting board.

We might have drove back to base blacked out from one of our training airfields. Seems pretty mundane after flying around blowing things up with them on.

Two tube. GPNVG is better for you older folk that down want to keep up a good scan.

What type of round?

Your are going to want at least ANVIS-6 goggles since they have stereo vision. External battery pack. Problem solved.

NVGs. Let me know if you need some training.

No, was already there, just posted some pictures for feedback. It will just be there for a week. Last weeks picture was moose dung carved out of hickory.

OMG I’m obscure woodworking famous.

This is bullshit. You need to slave away at more meta building for your own bench. Pfffffftttttt. Pretty sweet, almost went with that type of bench with the same vices. I feel like I need to get at least one Lie Nielsen plane to compare to the Veritas planes I have.

Someday I'm going to invest in a proper Starrett.

Wood without lube? Sounds like a terrible idea. Steve? Here is the dust port with the outfeed table down. Very easy to access.

I have it. Like it. No issues with dust collection when it’s up. When it’s down you still can hook up, just have to lift the table a little.

Ah, thought you meant the top. I would have the front flush since that is what the rail for the fence mounts to. More critical to keep that all aligned than the rear I would think.

Mine are just about perfect. You want them as close as possible.

What do you put on your cast iron tops?

I like carnauba. https://www.selfridges.com/US/en/cat/swissvax-crystal-rock-carnauba-wax-200ml_R00065220/?cm_mmc=PLA-_-GoogleUS-_-HOMETECH-_-SWISSVAX&POR=Y&utm_source=google&utm_medium=cpc&utm_campaign=na_na_pla-b_na_na_na_INT_USA-PLA-HOMEANDTECH-HOME&gclid=Cj0KCQiA-qGNBhD3ARIsAO_o7ymw7YD2G_zsVnSzAyT8sQPYLf58A7WMZ3F45dlN_m7hWBC9I62s6QEaAuyCEALw_wcB&gclsrc=aw.ds

I’ll check them out. Also plan on doing HDF ping ponged doors and faces.

I figured that was going to be your reference. I’ll see if I can find any books on it. Probably go the domino route for joinery.