July 9, 201213 yr amb has matched quads, and i noticed bdent is doing some kind of matching now too Amb doesn't sell them to outside builds anymore due to global shortage. I believe bdent is only for matching of 2sk170 to 2sk74.
July 9, 201213 yr i feel bad putting them in amps. Mouser agrees with you and marks them as NRND http://www.mouser.com/ProductDetail/Toshiba/2SK170BLF/?qs=xiNPFU0yZ8%2fdgDypNarXsxXfvvVlxESHRZQuMtxXTf8%3d
July 9, 201213 yr Author Mouser agrees with you and marks them as NRND http://www.mouser.co...ESHRZQuMtxXTf8= aw. no 2SJ74 though. if you check Toshiba's page, just about any thru-hole part is NRND.
July 9, 201213 yr Ha! - The BH thread would then explode with all the fanboyz asking Justin why their amps go up in smoke.
July 9, 201213 yr Ha! - The BH thread would then explode with all the fanboyz asking Justin why their amps go up in smoke. Either that, or people that "built" the amp and claim it sounds terrible....and want a refund
July 11, 201213 yr Do you think you will be selling the single channel boards you use on the GS-X and GS-1 ?
July 11, 201213 yr Do you think you will be selling the single channel boards you use on the GS-X and GS-1 ? Told you Justin. Oooh in addition to DIY kits, you should also offer fully assembled versions as well...oh wait...
July 11, 201213 yr Told you Justin. Oooh in addition to DIY kits, you should also offer fully assembled versions as well...oh wait... I was sure someone was going to comment in this way. I have the choice of how much DIY the amp is going to be. I could always try to do the amp like in the original article, on a breadboard, but I would prefer to have already designed and printed boards.
July 11, 201213 yr Told you Justin. Oooh in addition to DIY kits, you should also offer fully assembled versions as well...oh wait... I have to say...you called it.
July 11, 201213 yr If it's just a Dynalo you're looking to build, I would put up a wtb on headfi. I'm sure someone has some boards tucked away they weren't going to use.
July 11, 201213 yr If it's just a Dynalo you're looking to build, I would put up a wtb on headfi. I'm sure someone has some boards tucked away they weren't going to use. Done, thanks for the advice.
July 14, 201213 yr I know that your heat sinks would be expensive but I would be willing to pay for them even in unfinished form. I have the ability to drill and tap holes and can send them out for the finish I would like. Also, as mentioned above, RK50 would be nice.
July 21, 201213 yr Oh oh, before I forget, it'd be nice to get high voltage connectors for 2 chassis builds.
July 25, 201213 yr Author i just engraved these plates for vvs_75's blue hawaii build i can offer laser engraving for others as well. painted or powdercoated parts take the longest because of the thickness of the coating, which is also often very uneven. 3 to 5 passes are usually required. Most companies doing laser engraving seem to charge about $85 to $125/hr plus a one-time $125 artwork/setup fee. This particular job probably took 1 hour including making the artwork in the software, with about 10-15 minutes of engraving.
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now