luvdunhill

Anyone interested in a set of Bottelsen Aces High? They are 90% tungsten steel tips at 24g. Can provide a mixture of stems (aluminum and nylon) and flights with them. Just need to downsize a bit.

This might help: http://www.firstwatt.com/pdf/art_leave_classa.pdf

Anyone ever run across solderable bus bars? Here is a picture of them being used in a Rowland amplifier. http://www.shine7.com/audio/jeff.htm

Perhaps one of these Japanese machines? They are pretty cool.

This thread die? I will trying an excite it a bit. What grips do folks use around here? Do you prefer more or less contact with the shaft, for example a pinkie on the tip? More of a front loaded grip, or more rear?

The “pot grounds” as you call them, should be connected to the PSU ground. The two Dynahi chassis should be connected together. Then a ground loop breaker between PSU ground and the chassis. XLR pin 1 should be connected to the chassis. IEC Earth to the chassis via proper hardware.

Yeah, it’s this one: http://www.firstwatt.com/pdf/art_lxmini%20crossover.pdf

Yay, found the problem. Tomorrow will be listening day!

Installed the front end buffer boards. I will have to adjust DC offset outside of the circuit as the trimmers aren’t oriented the right way to be able to get at in situ. Now to track down a ground loop :/ (or what I am perceiving as one, based on frequency response graph)

A somewhat of a Franken-Pass.

I have used the Stax pinout, but since they use different pin geometries that probably isn’t a very rational decision

Asking the lady on your arm?

Added some fans to the outdoor rig https://imgur.com/a/xNXRTZB

Here’s the strap I bought, it’s alright - not Omega strap quality - the holes look like they will easily fray (the Omega seem to be burned through), which if I could rectify would be good enough.

I am really enjoying this one. It doesn’t feel too big. Only gripe is the date is a bit recessed, but probably due to the extra GMT complication?

Was thinking about a Cincy Straps, Goldfinger-era Bond, with that bit of red. Thoughts?

I purchased one of these today! Looking for a strap or two recommendations, something easier to adjust on the fly compared to a bracelet and makes the red pop on the face

None at the moment. I will keep you in mind, though, thanks! I have one more place to check locally, then might find look in Denver, as that’s where I am headed next.

Hi. Would anyone be able to perhaps help me track down a bottle a bottle of Foursquare 2005? http://thefatrumpirate.com/foursquare-rum-distillery-2005 I haven’t seen these on the shelf, but Spec’s has it listed as “Limited Availability” at their Houston store, for example. Thanks!

I used the SCA Service Center in NJ. This is the second piece I got back from them and they paid a lot of attention to detail. For example, they replaced worn screws in the band and realigned the crown so when tightened its pleasantly orientated.

Seiko did a wonderful job on maintaining my GS. Here is the clean bill of health!

Cheers Antonio!