jose

en av mina lilla nöjen … ☺️

Salud!!!!!

Thanks guys!!!!!

Thanks guys. It is a pleasure to celebrate this day with you !

Thanks!!!!

For me this album has the best solos of David. So much so that in "Division Bell", David again uses some riff and solos of this álbum.

A vinyl delight guys

Well done Mwl. A single pcb with two channels is very practical. I would like to add one of those amps to my collection but unfortunately, the KSC2752OSTU will be in BO until November. ?

add an electrostat CFA

For me it is difficult to distinguish anything. Resistors look like Vishay RN60. I don´t think they deserve to be changed unless some are burned. Wires, I don´t use anything specific, just a cable with an adequate thickness and a good dielectric. For the audio signal I sometimes use shielded wire (for microphones or music instruments) sometimes I use Mogami, Canare or just the one available in the electronics/music instruments store of my city…. nothing esoteric. Edit: This is my opinion. Obviously you can use the material you think is appropriate.

If you allow me, I would do all the wiring again. I don´t like having everything disorganized. There are many wires that cross, are very long or are placed directly on some components.

Marillion "Afraid of sunlight"

??

I´m so sorry... in all places there are monsters unfortunately. Descansen en Paz

I like how is playing Japan. Two nice goals

After doing 80 km on bike this morning I took a car ride. Towards a year that I didn't drive without top.

Thanks!!!

Between the GG and the BH there are differences of "nuances", but both sound very similar. I can´t do a direct comparison with Megatron. They are very different animals.

I'm not very good at describing sounds but you can imagine. Megatron has tubes in his pre-stage and this conditions su sound.

Matt Lange "Ephemera"

Updates: . With the E80CC has more gain. I think it is an improvement over the 6189. I like it much more with the E80CC. . JJ octett EL34 matched, off set is around 1~2volt. Balance 1~2volt too. It really deserves to invest in a completely matched octet (It's expensive but it makes up) Did I say that it runs very hot?

Happy Birthday!

Beautiful voices. Saving the distances, it remember me at Crosby, Stills & Nash

Coltrane Nice box with 5 cds.

I´m using the same kind of socket (but I prefer bakelite). So far I have not had problems. You can solder them to the Pcb without problem (always when you have a powerful soldering iron, about 25 / 30W). I recommend that when you solder them to the plate, you have a valve inserted. This will keep everything aligned.