I've done the shelves for my new audio rack, so with the rack complete here are some photos.
The first photo is of my old audio rack showing how I had my headphone system positioned.
Here are the photo's of my new rack starting with just the frame.
Now with the shelves which are MDF covered in carbon fibre wrapping.
The next is with my headphone system.
Sorry about the poor quality of the photo's, but at the moment I've only got a cheap camera.
Because I wanted the BHSE's amp section to be a little higher on the shelf, I had a local metal engineer to alter 4 support feet I already had, so my isolation cones would fit in them which can be seen in the photo below.
Like with the BHSE's amp section, I want all the units on the rack to be lifted so I'm going to have a few more of the supporting feet made.
As can be made out, some marks on the wall to the right of the photo's are where I've been painting that wall.
Because the paint was still wet, in the last photo I couldn't put the rack as far back as I wanted because I didn't want paint to get on the power cords and interconnects, so in the photo below the rack is away from the wall.
When the paint's dry, the rack will go closer to the wall and when that happens the stand at the side of my old rack in the first photo, will be showing, with photo's of the new rack it can't be seen because it's behind and to the right of that rack.