Couldn't find any chairrail to match existing, so I milled some up.
Took longer to clean the shop up, than it did to mill the rail.
And now the shop has two more specialty router bits.
well the missing bolts arrived and the free 20W laser... so I had some fun trying to burn front panel markings.
After a few experiments I realised the default settings in light burn are insane...6000mm/min movement speed no way! and 0.1mm between steps does not provide good resolution and gives a streak effect on text and slightly jagged lines... I improved by changing the settings to two passes at 90% power, 0.05mm stepover and 1000mm/min. This gives a crisp result (crisper than my camera phone can show).
The result is not a shiny as engraving with an actual 10degree 0.1mm engraving tool, so I will experiment a bit more. I guess I am still not quite getting all the way through the anodizing.
Had some friends up in Maine; nice lunch overlooking the ocean (past a pool), then poking around Kennebunkport and Cape Porpoise. Looked like someone was home in the Bush estate, not pictured but there was a Secret Service vehicle parked there. Also a pic of the lighthouse at Goat Island, in Cape Porpoise.
RIP Joe Turkel, worlds most famous bartender and replicant creator. I didn't realize you played both (among others).
https://www.yahoo.com/entertainment/joe-turkel-actor-shining-blade-034336342.html