Leaderboard

steak

Better (restored) audio to do it justice.

Keith Jarrett - Standards Vol.1

Wrapping up the kids bathroom renovation for the boss (while they're on vacation in Ireland). I still have a third shelf to place between the top and bottom shelves, under where the vessel style sink will live. But I need to wait for the plumber to finish plumbing the sink, so I know where to cut around the drain P trap. It will most likely not go from wall to wall like the top and bottom shelves, but will most likely get cut shorter and be mitered back up to the top shelf. Kind of a reverse waterfall. These shelves are milled from rough Redwood. Not the wood I'd choose for a child's bathroom. It's just so soft, that anything will leave a dent. But that's what the boss wanted. Got the wallpaper installed, then the medicine cabinet. As well as the mirror and two floating shelves above the toilet, (toilet not yet installed). And installed the new light fixture, TP holder and shower curtain rod. Re-purposed an old door for the pocket door. All that's left is the middle shelf and putting on the shower curtain, which I've left off to give the plumber more room to do the shower trim out. Plumber arrives Saturday. Boss' wife and kids arrive Sunday. Boss arrives a week later.

Hey grandpa, you have more sun protection than the baby!

Ack, I apologize simmconn, yes its the “ok” board. I’ve been wracking my brain on this and failed to recall you’d already pointed out that the OK is def not OK. Thank you for your help, will investigate there, makes perfect sense.

Is it the 'ok bias' channel in your schematic that has large output offset with servo disabled? I gave my analysis in my post. Q24 and Q25 form a current mirror. The current through R21 should be the same as the current thru R31 and thru the R26. Apparently it's not the case based on your measurement. I would focus on the related few components.

I'd measure the voltage across each 1 ohm resistors, then the 1m, 100, and 560 ohm resisters.

Chili pork & beans (and other veggies: celery, mushrooms...okay, just those two) -- delicious!

It's possible, although my soldering skills are pretty developed. I like use Kester 186 liquid flux, Kester 44 60/40 solder and a decent Hakko Iron at 750*. Taught by a guy who helped make some electronic parts for the F117 fighter as a civilian contractor even. Everything is always nice and shiny and liquid looking. I wonder if like tubes, a tester only tells you a part of the picture. I've had numerous tubes test OK on a tester, but not in circuit.

@jpelgI have been watching Silo, I thought it was a bit of a slow starter but has picked up since. I suspect we will find out why they are underground as the series progresses.

Is everybody happy?

The V Files: The Shocking Legacy of an ’80s Sci-Fi Cult Classic Hollywood backstabbing, conspiracy theories, and the devastating murder of a star behind the TV alien-invasion sensation. https://www.vanityfair.com/hollywood/2023/05/the-v-files-legacy

William F. Buckley Jr., Jack Kerouac, Lewis Yablonsky, and Ed Sanders strangely discuss "The Hippies" (with Allen Ginsberg looking confused in the audience)

In other news George Winston, pianist, has died. https://www.npr.org/2023/06/07/1180774279/george-winston-new-age-pianist-obituary?ft=nprml&f=191676894