luvdunhill

Yeah, I would run them in a modified H-Frame which will behave like a Slot Load (so open back part of the H and the front part would be angled down into a wedge). The AE drivers are made for OB and have the desirable properties you mention plus sensitivity that can easily match a full range driver... even available in 16 ohm impedance.

Thanks all!

PentaLogix ViewMate should work

[mention]naamanf [/mention] perhaps?

Has anyone listened to a system with the Acoustic Elegance dipole woofers? I was looking for a high Qts OB driver and ran across them.

So, basically vegan ambrosia maple? I dunno that seems a bit too far.

Finished the front panels on my phono pre. Nevermind Stephen “Bishop”’s creepy photobomb ...

They are called board-to-board connectors.

All worked well. Sliced up the ply into 1” strips and then used the pocket jig to make a frame. I think 1” is too narrow so will probably do 1-1/2”.

Tomorrow I am going to cut up some remaining Baltic Birch ply to make some frames for speaker grills. That will involve a bit of clamping and screwing here and there. So, stay tuned!

It seems to work great! I am not a huge fan of using a long screw driver to attach the top - having pre-drilled pilot holes would be nice. Other than that; it’s bolted to the ground and super stable. I sanded and put a coat of finish on my phono preamp faces just now!

Yeah, 54" model. I will have a few projects on it this week and will report back!

A workbench!

The one swt61 has has digital out.

So, glue is basically solder, right?

Pretty nifty!

Isn’t a dongle the answer? Ya know, use the camera kit connector with the USB-C to Thunderbolt connector to Lightening Cable?

So the threaded rod goes all the way through the legs? I don’t get where you are putting your nuts?

Glad someone figured out tube pins could be used for decent Stax sockets

Success!

I am considering what would be a 5.2.2 Dolby Atmos System which would leverage some existing ambient speakers for the “overhead mids” with a switch in the wall to toggle them. Here is the guide: https://www.dolby.com/siteassets/technologies/dolby-atmos/atmos-installation-guidelines-121318_r3.1.pdf

I am really excited about the Marantz NR1711! https://www.us.marantz.com/en-us/shop/avreceivers/nr1711 Pretty featured packed. Will be my third slim-line, following various updates they have made.

Cool, thanks for sharing!

I used tap magic (because I had it on hand, and it smells nice). Maybe there are better choices? I also tried a spade bit (not pictured) but it wasn’t nearly as good of a cut as the others.

Did the same thing. But wasn’t smart enough to think of the dealership, so called the Fire Department. Yeah, took some explaining.