luvdunhill

I prefer acquiring O2 and getting rid CO2 whenever possible.

I'm pretty sure that dimension is just the distance from the center to the outer edge of the mounting hole. If you then look at the far left diagram, the PCB seating plane looks higher than that.

check the title. no, not that part, the part where it says "new member".

Once you go dark, you never go back. So I've heard.

sure. seriously though, I cannot believe that dimension isn't on the PDF. how lame.

and one more question... how the hell do you know how far off the PCB the center of the large mounting hole is for these? Neutrik - Audio - A Series - NC3MAH-0 I suppose you have to load the DXF file? bah. I don't have a way to do that...

woah, he's been banned? jkeny's profile - Head-Fi.org too bad, he would have fit in well around there. Any details?

in your opinion, what's a reasonable connector to use with DSD and other serial audio signals. cat-5? Assume that the runs will be very short, and proper precautions are taken on each end of the connector.

ah. double drat.. you and your logic.

drat. Maybe something on a bit smaller scale?

Duggeh, any interest still in the project?

bump

10 Things the Internet Has Killed or Ruined (and 5 Things It Hasn't) - PCWorld

10 Things the Internet Has Killed or Ruined (and 5 Things It Hasn't) - PCWorld

I really like the WM8741

This is video we are talking about.

Why not just use two long pairs of shielded stereo RCA cables? I bet you can find those cheaper.

just want to check one things. The wire holes are .06" and the test points are 0.08"? Any other test points, other than the marked locations that make sense to add a terminal? ground perhaps?

It's pretty hard to find something that isn't functional for that use.

Trendsetter How close? At least what the LSK389 specs as max diffference.

That's correct for the PTP3. I'm not positive about the hex screw, it could be that the stops are used and the friction of the tire on the spindle keeps it in place and effectively against the stop. Regardless, I'm not doing it that way so I didn't look into it very much.

The previous versions have a mechanism to set stops for different speeds. I'm not sure about the most current version. You still need to remove the platter and potentially loosen and retighten a set screw. This allows adjustement to a different diameter on the motor spindle.

four would take up a lot of room on the two cups.

Yeah, it hates fat partitions.

I'm eating Edam and Wheat Thins. I want bread though now