Leaderboard
Popular Content
Showing content with the highest reputation on 05/22/2023 in all areas
-
2 points
-
2 points
-
2 points
-
1 point
-
1 point
-
While not technically Europe, friend who moved to London a year ago said he and his wife have had no issues with US iPhones, including geolocation. I don’t believe he’s switched over to eSIMs though, so not sure the complications there.1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
400mV is around 10x too much for the offset. 8 rotations are normal for the bias pot until you start noticing the voltage increase. The pot has around 30 turns or so. 150 to 200mV would be in range.1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
1 point
-
tiny mistake: FQPF8n80s -> FQPF8n80c. But anyway, FQPF8n80c completely obsolete. May be it make sence to change it on FQP8n80c. PS: compared to previous gerber version fixed wrong silk for IXCP10M90S: KAG -> GAK, good 👍1 point
-
Hi guys, I spent 2 months building a T2 and today was expected to be the day of completion, but it exploded. When the power supply is not loaded, everything is fine and the correct voltage can be output. However, I connected the amplifier and turned on the power, and after 6 seconds of high voltage start-up, the power supply exploded. 10M90S I get it from MOUSER, it should not be a fake. I set both RV1 and RV2 in the center. The explosion killed the 10M90S,fqp8n80c,1N4007 and 1n4751a at +500V, and the same situation over at -500V. Did I do something wrong?Why did it explode?Expect someone to answer,THX0 points