Speakers

Some of you might recall me having some issues with my Cicadas just a short time ago; if not here was my comment from a week/few weeks back: I followed the suggestions that were given to me concerning placement (thanks again fellas), and it does seem to be a little better now, but the low-end in particular still is imbalanced with the left side playing more strongly. Well, today I was messing around and happened to peer into the porthole on the right speaker with a flashlight, and this is what I found: This is what the left side looks like: And one more comparison to the bottom of the speaker: ^ Left ^ ^ Right ^ ~…

I rarely do any real critical listening due to the amount of work I have from school so I've been thinking about moving to a small speaker system for a bit. I dont really want to hassle with an amp to go with the speakers since I'll be moving around a lot and living in a small dorm room doesnt give me a lot of space to work with. I've been looking for the Audioengine 5s (just missed a pair of Audioengine 5s for 200 ) and Quad 11Ls on ebay and audiogon. Is there anything else I should keep an eye out for? Max budget is $400 btw

Here's what I've been selling off my high-end headphone gear for. Just moved them in an hour ago. Unfortunately I'll have to wait a bit to give them a listen, as I've got some work to catch up on! Also, mine is the only residence in a block of businesses, so I need to wait until evening to crank things up Uses a 10" dual-concentric driver with all the specs of the TOP end of the Prestige line. That means Alnico (Alcomax) magnets, twin-roll impregnated fabric surrounds, doped paper pulp bass drivers, 2" round-wire wound voice coils, and the special Pepper-Pot tweeter waveguide instead of the Tulip waveguide used on the lower lines. There are separate magnetic motors fo…

Hey guys, I've been away from HC for about 2 months (I miss you rascals ) due to some major home renovation and because I took up 12 weeks of industrial attachment as part of my Eng degree graduation requirement. Anyway, I wanted the get opinions from you guys about using solid cement/concrete blocks for speaker stands. You see, since my house is undergoing renovation anyway, there are a lot of bricks and cement just lying around. I figure I'd just ask the construction guys to make me a stand like the one below: The pic above is not mine; it

I've mentioned in the past how good I think the D-Sonic's are and how they use the exact same ICE Power modules that the Bel Canto Ref1000 and other amps use. Well here's some proof: Bel Canto Ref1000 pic taken from 6moons: D-Sonic Magnum 500M: Notice that everything except for the rca/xlr connectors and binding posts are completely identical. Right down to the aluminum bracket/heatsink that the boards are mounted to .

linkage If TKAM or any mods want to post the HC amazon link for them here feel free.

Waffling context begins... My parents house has two front rooms, one of which has been since year dot the living room, and has the television and sofas and is generally where people sit and veg out or chat or read the paper or whatever. The other front room has been known since I was a little kiddie as "the music room". It wasn't called this because mum played cello in there, or because there's a piano, but because it is where my dad installed his hi-fi in the mid/late 80s. (Mission DAD7000, Quad 34/405-2, Monitor Audio speakers) The DAD7000 is long dead (could only be a good thing ,some would say, replaced since then with an Arcam Alpha 7) as are the speakers…

I'm trying to decide what would be the best use of my money. I recently purchased a pair of Audioengine A5's, and I like them quite a bit. However, I recently became aware of the NHT M-00's, and I could probably afford a pair of those if I stretched my budget. The way I see it, I have two options. I could keep the A5's, add an Onix X-Sub, and call it a day. That would probably make for a pretty sweet 2.1 system. Alternatively, I could return the A5's and buy the M-00's, which I would imagine perform at a somewhat higher level than the A5's. I couldn't use my X-Sub in that setup, but that's not a deal breaker for me. It would probably be a long time before I could …

My old ass Harmon Kardon AVR-85 is losing it's channels one at a time. The surround channels are all but dead. But all the Pre outs work. So, I was thinking of using it as a Pre amp until I replace it. And get a Multichannel amp to power the 5 speakers I have now. (NHT Super Zeroes). My Velodyne HGS10 sub is still working (knock on wood). I plan on getting the Smyth Research Realiser as well, so single ended amp recommendations only, please. Eventually I'd like to get a better Pre Amp/processor (maybe the Emotiva UMC-1), but as of now, I'd like to keep my speaker related purchases as small as possible. (Around $500 hopefully, maybe up to $800) While it w…

Does anyone know anything about these speakers? Since they are made by Final Sound, I presume they are inverted ESL, though this model has a 7" alloy woofer handling the low end with the 48" ESL panel for mids and up. There obviously are going to be some issues with reflections, and I bet they are very sensitive to the room, but still, pretty interesting looking. Seen a few good reviews, but from unknown sources.

I currently have a yamaha M80 amp that I found on craigslist for 150 bucks but I've been getting the itch to upgrade. I have no experience with speakers and don't know what a decent budget amp for magnaplanar speakers would be. What would you recommend?

Pretty nice little package. 12"*12"*14", sealed 10" woofer, 50lbs, 1000W RMS, claimed 23Hz extension, $800. If I ever get a sub for the office rig, this will be near the top of my list. Only thing I can think of that would probably do more for less is the Epik Vanquish at $700, but that's quite a bit bigger and heavier.

I have a rather cramped situation that requires somewhat creative furniture placement, by using a single room as a bedroom, electronic workshop, and listening room. As it is now, things are fairly good and the speakers (Maggie 1.6) sound wonderful. However I want to build a new workbench that is significantly larger, and it would require getting rid of a set of shelves and making the room too cramped, or rearranging furniture to make better use of the middle of the room rather than everything against the wall. Moving the listening position near the middle (by setting the desk in the middle so I could listen from there) is a no go, because there is a massive bass null a…

As some might know Porsche has released a new 4 seater which wouldn't be news to us except it has a Burmester audio system with... wait for it.... AMT tweeters. Here is the story So Douglas, start saving up those pennies...

I was looking at building a pair of speakers and was thinking about doing something a bit wacky... has anyone heard the planars they sell on parts express? those Bohlender Graebener ones... either the smaller ones or the insanely large ones? ex. Parts-Express.com - Search Results i found a few projects online using the smaller Neo-8 in both single and line-array configurations... and then all sorts of insane projects using the RD75 75" planar driver with line arrays of larger drivers next to them etc... anyone ever actually listen to any of these things? lol thanks

Hi everyone. One of my tweeters for my 400i PSB speakers is blown out. I was wondering where a good place would be to try and find a replacement tweeter. I honestly never did try and find a replacement tweeter before so this is new territory for me. I sent an email to PSB in hopes of purchasing one from them if they have one, which seems unlikely after doing some research on the net. I put a WTB ad in audiokarma as well. It seems that a website called Madisound Speaker Components | Assisting speaker builders for more than 25 years. used to sell the replacement, but they don't offer it anymore. I will try and call my local authorized PSB dealer to see if they do…

I got back one of my C-22 preamps and my MC-75 monoblock from the repair shop yesterday. I've had these things for a decade, and I'm just now getting around to dealing with them properly. I haven't plugged the MC-75 into anything but the AC outlet so far, but I did just spend half an hour futzing around taking pictures of it: The case could use a good cleaning, but I'm not sure what cleaning product one uses on vintage tube amps. The repair tech tested all the tubes and said they did quite well. I understand the power tubes used the MC-75 are quite spendy to replace. I don't have any pitures of the C-22 preamp yet. I'm going to try to integrate it as a phon…

So after 3 months, I'm getting bit tired of needing to get up each time I want to change the volume. Assuming some unexpected expenses don't come up, I've been thinking about Adcom GFP-750, maybe in a month or two. Are there anything else I should be looking for? Also, anyone know anything about PS Audio's P-200?

So there's a local guy selling his Dynaco ST-70 for a pretty fair price ($300) and a pair of Magnepan MMG's ($300) also. I was curious if you guys have any input on the Dynaco amps.

So my director asked me to like get something for his office for music/demos/whatever with a budget of ~500 in total. I would have some suggestions 2 channel or 2.1, but any more than that is kind of beyond my experience outside of computer speakers.. any recs?

Some poking around has led me to believe that DHT preamps should be really (really) good or their proponents are just very vocal about their choice I'm wondering what people here think? 26 tube DHT preamp another 26 DHT

Any thoughts on the Outlaw Audio M2200 amps? Outlaw Audio They are class G amps, and I know Barry Diament at SH forums really likes them with Maggies. And they're cheap and easy to resell. Model 2200 Technical Specifications * Power Output (FTC Continuous RMS): - 200 watts @ 8 ohms, 20 Hz 20 kHz, < 0.05% THD - 300 watts @ 4 ohms, 20 Hz 20 kHz, < 0.05% * Short Term Dynamic Power Output: - 300 watts @ 8 ohms * THD Signal to Noise: 100 dB (unweighted) * Input Impedance: > 10K Ohms * Gain: +27dB (1.7V sensitivity) for full output * Input Connectors: RCA Jack * Output Connectors: Fi…

just a few teaser pics of these speakers mark reid built for my lady friend. the rest of the story will be given when i have more time. forgive the poor pictures. they really dont do justice to marks work. needless to say they sound out of this world. more eargasm accounts to be given.

Ooooh, shiny: McIntosh | Special Edition Only 60 will be made for the USA...hrmm, anyone here think they'd get one? Price: $15K for the pre-amp and monoblock system

I created a similar thread at Headfi a while ago and I'll paste the links I was offered over there. I'm now much more serious and once again interested in any good reading for room setup and treatments. I'm especially interested in room design and getting the most performance if one is able to start from complete scratch. The links offered up for those interested: Jon Risch's Web Site- Acoustic Treatments Real Traps Ethan's Magazine Articles Auralex Audioholics Tweaks