Forums

I think to honor his memory, Liz Cheney should run for office again.....as a Democrat.

One update on my ailing SR-X1, I went in one last time and coated them again and that seems to have done the trick.  No imbalance at all and just some mild buzzing from the driver as some debris got in there.  I might go in and try to clean it but yeah... that's the good news.  Now for the bad one as I'm afraid the X1's are not long for this world.   So this was the first time I took the driver fully apart and whoever designed this needs to go and look at how Stax used to be made.  I've never seen them do this before but the diaphragm is only attached to one ring, not sandwiched between two of them.  So the spacers they use (also the insulation from the stators) are different from one side to the other.  The side with the metal ring is very thin indeed, probably 0.2mm or so.   I didn't want to snap a picture as the whole thing is so fragile but yeah, the diaphragm is hanging on 2-2.5mm or so of metal spacer and mine was already lifting off the ring as the PEEK seemingly doesn't adhere well to it.  I'm sure I didn't cause this and it is very worrying as they have so small a support for the film.  I have some SR-X NB diaphragms here and there they used 4mm spacers and glued on both sides for a much smaller diaphragm.  That means the films are still just fine after 50 years in service which I doubt will be case for the X1's.   I for one don't see an issue with gluing just one side as I do the same on my DIY drivers, but the contact area has to be bigger and mylar behaves differently to PEEK.  Right now this set works fine but I'll continue to monitor it and I'd like to know if anybody else has had these issues.   I finally got around to watching this and a few interesting bits, they are clearly still making 009 drivers as they were pulled out of a drawer in the soaking oven even through they are long out of production.  Odd that they don't swap them out with 009S drivers as they have done with every other model.   I did roll my eyes when only 30 X9000 drivers could be tested by one person... sure... why not I found it interesting that they test the drivers like that, as the reflection off the table is surely messing up the test by loading one side of the driver differently.  I always thought they would slot them into jigs with microphones on each side as this way makes no sense to me.   Btw. I feel their museum severely lacking...  I know a few people who have a lot more Stax stuff in their collection than that.        

Famous Blue Raincoat. Songs of Leonard Cohen by Jennifer Warnes (1986) https://open.qobuz.com/album/0826663104905 Example: Very well recorded Jennifer. 

It always 1969 (nice) in Alaska. Bob & Carol & Ted & Alice  

Caira (formally Alice) AI camera reviews. Changes coming.